16.06.2016, 18:00
Ich habe den Stromer ST2 s mit der noch (fehlerhaften) Software 3.0.1.3533. Hier gibt es die Option "Sensoren kalibrieren". Kann mich jemand aufklären, was es damit auf sich hat?
Software Release und ST2
|
|
Nachrichten in diesem Thema |
Software Release und ST2 - von Pixie13 - 16.06.2016, 14:31
Software Release und ST2 - von ere - 16.06.2016, 15:39
Software Release und ST2 - von Pixie13 - 16.06.2016, 15:51
Software Release und ST2 - von Epikur - 16.06.2016, 18:00
Software Release und ST2 - von Pixie13 - 16.06.2016, 18:46
Software Release und ST2 - von bluecat - 16.06.2016, 19:35
Software Release und ST2 - von emdless - 16.06.2016, 21:21
Software Release und ST2 - von Pixie13 - 18.06.2016, 01:04
Software Release und ST2 - von emdless - 18.06.2016, 11:20
Software Release und ST2 - von Pixie13 - 18.06.2016, 11:37
Software Release und ST2 - von emdless - 18.06.2016, 18:02
Software Release und ST2 - von Pixie13 - 19.06.2016, 02:00
Software Release und ST2 - von emdless - 20.06.2016, 16:24
Software Release und ST2 - von emdless - 24.06.2016, 17:41
Software Release und ST2 - von ere - 24.06.2016, 19:26
Software Release und ST2 - von Pixie13 - 28.06.2016, 17:20
Software Release und ST2 - von manfred682012 - 28.06.2016, 19:41
Software Release und ST2 - von Satbird - 28.06.2016, 19:56
Software Release und ST2 - von Pixie13 - 28.06.2016, 22:39
Software Release und ST2 - von manfred682012 - 29.06.2016, 06:56
Software Release und ST2 - von Pixie13 - 30.06.2016, 01:17
|